Jonathan Millis

Im currently making an Infrared break beam audio trigger with two potentiometers to control some audio effects. In the Arduino serial monitor I have all the different IR beams and pots scrolling down in their own individual column. In max I have unpacked the serial data in to one float number. This is all right with the IR sensors because I have split up the different IR break beams using a split argument to trigger different sets of samples. Each IR sensor gives out a different set of numbers for on and off eg 0,1 then 2,3 ect ect. This allows all the different IR break beams to essentially act as different sections of a band. However the pots need their own float number so they can control audio effects, currently they interrupt the IR beams being split up. I thought that because they were in there own column in the Arudino serial monitor that it would come out of the second float number attached to my unpack argument serial monitor. Im pretty sure its the max patch but I have no idea what it is. Does any one know where im going wrong with this? I tried using the funnel argument but that again didn't work. Any help would be greatly appreciated.

Im currently making an Infrared break beam audio trigger with two potentiometers to control some audio effects. In the Arduino serial monitor I have all the different IR beams and pots scrolling down in their own individual column. In max I have unpacked the serial data in to one float number. This is all right with the IR sensors because I have split up the different IR break beams using a split argument to trigger different sets of samples. Each IR sensor gives out a different set of numbers for on and off eg 0,1 then 2,3 ect ect. This allows all the different IR break beams to essentially act as different sections of a band.  However the pots need their own float number so they can control audio effects, currently they interrupt the IR beams being split up. I thought that because they were in there own column in the Arudino serial monitor that it would come out of the second float number attached to my unpack argument serial monitor. Im pretty sure its the max patch but I have no idea what it is. Does any one know where im going wrong with this? I tried using the funnel argument but that again didn't work. Any help would be greatly appreciated.  

Arduino to Max: unpacking Arduino serial data in to individual float numbers??