quimsy

I am trying to use the 128 to CC with scalable output tool (

https://cycling74.com/tools/128-cc-scalable-output/#.Vegh6uRRGUk).

I want to be able to control a flonum with this, so that if I input a value into the flonum and then move the dial, I want the inputed value in the flonum to be the starting point, and have the dial scroll relatively to that in both directions.

ATM after having input any value into the flonum, on touching the dial it resets to zero or seems to revert to a previously 'memorisized' value. I want to scroll between 0 and say 20000 (not just 0-127) with no jumping.

I am trying to use the 128 to CC with scalable output tool (https://cycling74.com/tools/128-cc-scalable-output/#.Vegh6uRRGUk).
I want to be able to control a flonum with this, so that if I input a value into the flonum and then move the dial, I want the inputed value in the flonum to be the starting point, and have the dial scroll relatively to that in both directions.
ATM after having input any value into the flonum, on touching the dial it resets to zero or seems to revert to a previously 'memorisized' value. I want to scroll between 0 and say 20000 (not just 0-127) with no jumping.

dialflonum-problem

Thanks for your reply - the patch you posted is kind of right, but it's only operating within the 0-127 range, so I cannot move the dial more than 127 units from the value displayed on the flonum.

I want to use the flonum with the attached 128 to cc tool - This takes 0-127 midi input and mimics a continuos controller message by sending out an "increase by one" message when above 127 (and vice-versa below zero) into Max. How do I modify your patch to accomodate this?

Thanks for your reply - the patch you posted is kind of right, but it's only operating within the 0-127 range, so I cannot move the dial more than 127 units from the value displayed on the flonum.
I want to use the flonum with the attached 128 to cc tool - This takes 0-127 midi input and mimics a continuos controller message by sending out an "increase by one" message when above 127 (and vice-versa below zero) into Max. How do I modify your patch to accomodate this?


dial/flonum problem