Kevin

I've been working on a college project the past few weeks and I'm just about finished it with the exception of one small section. I'm using a flex sensor to move a selection of an rslider object to the left or right at a set rate depending on which way the flex sensor is bent; And then have the selection freeze if the sensor is straight and idle. My only problem is I cant get it to start moving right after it has begun moving left or vice versa and then obviously cant figure out how to just freeze the number if the sensor is straight.

I know I might be going about this using a slightly awkward method but it seemed like the most logical way to me until I hit this obstacle.

Any advice is greatly appreciated as usual!

incrementdecrement-and-freeze-a-number-using-flex-sensor

There is probably a more elegant way, but I am out of time now!

There is probably a more elegant way, but I am out of time now!
Hope this helps.

Increment/Decrement and freeze a number using flex sensor