Chris Gough

Im looking at the best way to get the current clips playing position as a phasor~, so i can then rate~ and generally manipulate the signal, to create stepped signals etc...

Would I just have to re-trigger a phasor~ that's synced to the transport or is there a better way of doing this?

I am currently using "playing_position" but as a message, that's not as flexible as a signal.

m4l-clip-playing_position-as-phasor

Was going to start a new post for a similar question but might make more sense just to expand on chris's question a bit.

Does anyone know of a way to get the current clips play position as a position in the waveform. ie the current sample of the waveform that is being played even if it is warped or using the beats warping algorithm and doubling back on its self. The aim here is to drive a jit.qt.movie... i suspect chris's motivations are the same :)

Was going to start a new post for a similar question but might make more sense just to expand on chris's question a bit.  

Does anyone know of a way to get the current clips play position as a position in the waveform.  ie the current sample of the waveform that is being played even if it is warped or using the beats warping algorithm and doubling back on its self.  The aim here is to drive a jit.qt.movie... i suspect chris's motivations are the same :)


M4L Clip playing_position as phasor~