Graham Foster

I'm trying to create a new patch and I can't proceed any further. I've done hours of googling but for some reason I can't find a straight answer. I'm sure the answer is staring at me right in the face, but it would be great if someone could point me in the right direction.

I am trying to get multiple midi channels routed from Logic Pro, and into MAX7 to all be used simultaneously. At the moment, I have the "notein" object with loads of "if" statements routing the midi notes to the right channel sound. To put it plainly, I have 4 midi channels route from Logic, then "if" statements routing each midi channel to a different area of the patch to produce a different sound. The problem with this, however, is the fact that only 1 message is being played at a time. So some notes are getting lost/cut short because a new note has replaced the message on a different channel.

I've been trying to work out how to use the midiin object for ages, but for some reason it doesn't like accepting midi from "from Max 1" , it works fine with my hardware MIDI controller.

Hi there,
I'm trying to create a new patch and I can't proceed any further. I've done hours of googling but for some reason I can't find a straight answer. I'm sure the answer is staring  at me right in the face, but it would be great if someone could point me in the right direction.

multiple-midi-channels-on-max7

You can set integer arguments for notein which are equivalent to the channel number.

Literally as I posted this it hit me.
You can set integer arguments for notein which are equivalent to the channel number.
Sorry, my bad.


Multiple MIDI Channels on MAX7