Liang Mei

Why does my signal media didn't sound like been changed a lot when the amount of the modulation is set to 1, no matter how much I adjust the frequency at the top in my code? However. when modulation is bigger, the effect becomes obvious a lot. I can't tell the difference through the scope:)

comment

number

flonum

scope~

cycle~

ezdac~

live.gain~

tri~

Why does my signal media didn't sound like been changed a lot when the amount of the modulation is set to 1, no matter how much I adjust the frequency at the top in my code?  However. when modulation is bigger, the effect becomes obvious a lot. I can't tell the difference through the scope:)

Why does my signal media didn't sound like been changed a lot when the amount of the modulation is set to 1, no matter how much I adjust the

modulation-frequency-questions

i suppose it's because the difference in frequency is too small (it will not exceed +1 /-1 ; so for example if your carrier is at 440 Hz it will oscillate between 439 and 441 Hz). The index should have big values like hundreds or even thousands :)

and AM is positive only, not through zero (that´s RM what you are doing here)

Modulation frequency questions